Oxygen Sensor Electronic Simulator


Attention: Bracket Racers, Off Roaders, Hi-Performance [outlaw] Street Machines !

This device will allow you to remove the CAT on any 1996 and newer Dodge trucks. This unit has been tested on Dakotas, Durangos, Rams, and JGC. It will work with the 3.9 V6, all of the V8s and V10 engines up to 2003. It will work on the Vipers and SRT10 Trucks. It will not work on the Hemi and new Drive by Wire TB's.
If you just remove the cat, and possibly the post cat O2 sensor you will get irratic idle, loss of performance, and a never ending MIL light ...
We have the answer! The EAS Enterprises Post Cat O2 SIMM ! This device completely fools the PCM, it thinks you have a very efficient CAT installed. Simply replace the post cat O2 sensor with this device.
The circuit board is computer grade fiberglass / epoxy, all of the components are MIL Spec, close tolerance. The board is dipped in epoxy paint, installed in the high impact ABS case then potted with high grade epoxy. This makes it totally vibration proof, and extremely moisture resistant. This yields a device that will work from -50' F to 250' F ...
This part also will correct the problem of the Check Engine Light when the stock Cat is replaced with a Highflow Performance Cat.

These are for OFF ROAD USE only.

Add to Cart:

  • Model: O2 Sensor Electronic Simulator
  • Shipping Weight: 7.95lbs
  • 1 Units in Stock

This product was added to our catalog on Thursday 24 February, 2011.

Customers who bought this product also purchased...

Copyright © 2016 3rd Strike Performance. Powered by Zen Cart